![]() ![]() I've read the posts on the serial number saga and unfortunately my serial number is 4M950027. > In some cases, the 'CAT' symbol appeared on the rig, but the radio failed to connect. ![]() After a few unsuccessful attempts (many), I then tried to use flrig via a USB (CH340), CAT-847, FTBCAT and FTBASICMMO. ![]() > I have been trying to connect my FT-847 to my RigPi. > As far as I can tell, your FT847 is a november 2004 model which makes it one of the last ones (2005) produced. > What is there unfortunate about your serial number? Are there any other avenues open for me? Many thanks Yaesu have just mentioned that they do not support the firmware update at present. I haven't been able to decode the data yet, but would this kind of patch work? See I've read the posts on the serial number saga and unfortunately my serial number is 4M950027.Īnyway, while trying out the programs above, I found something called CommsTester and this allowed me to 'see' the incoming data while tuning the rig.This is what is see: In some cases, the 'CAT' symbol appeared on the rig, but the radio failed to connect. I have been trying to connect my FT-847 to my RigPi. What is there unfortunate about your serial number?Īs far as I can tell, your FT847 is a november 2004 model which makes it one of the last ones (2005) produced. The rig was sending back to the CommsTest program when tuning across a Serial number is "4M950027", hence I was wondering what data is that That would mean that the port was unidirectional prior to this, my Later serial numbers (e.g.,ĨL09nnnn) all seem to have incorporated the earlier improvements plus new Yaesu had corrected the bi-directional CAT issue and made some other "D" means February, "E" means March, and so forth.Įxample: 8G051234 = 1998, May (fifth month, or "G"), Production Run 05, unit Number, where the month of manufacture is offset by 2, so "C" means January, Year of manufacture-Month of manufacture-Production Run-Individual Unit ".Yaesu appears to use the following format for serial numbers on their The Serial number that I made reference to was from a post: Programs fail to complete the connection. In both cases, the 'CAT' comes up on the rig, but I've used a Serial to USB cable to connect the rig to the Raspberry PiĪnd the laptop. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |